PB-16

• Paper drilling
• Cooling and lubrication systems to extend drill bit life
• Stroke and spindle controls
• Five drilling heads
• Drilling belt as the drilling bed instead of drill sticks

• Drilling heads: 4 heads standard, up to 13 heads or multi-spindle heads
• Hole distance: 1 1/4” – 16 1/2” (31.7 – 420 mm), with multi-spindle drill heads down to 3/4” (19.05 mm)
• Spine margin behind drills: 2” (50 mm)
• Size of front tables: 17 1/2” in width x 12 1/2” in depth (450 mm x 320 mm)

Manual Sliding Table

• Hole Distance: From 9/32” to 16 1/2” (7 to 420 mm)
• Hole patterns: One program trim with common hole patterns included with machine purchase; additional program index trims are available with up to 7 hole patterns per trim
• Size of sliding table: 17 1/2” W x 12 1/2” D (450 mm x 320 mm)
• Traveling distance of Sliding table: 12 1/4” (310 mm)

Programming Sliding

• Hole distance: 3/64” to 16 1/2” (1 to 420 mm)
• Hole patterns: Store and recall up to 100 programs, program any hole pattern via touch screen
• Size of sliding table: 17 1/2” wide x 12 1/2” deep (450 mm x 320 mm)
• Traveling distance of Sliding table: 12 1/4” (310 mm)

Large back table with manual backstop and optional programmable motorized backstop

• Throat depth behind drill bits: 12” (300 mm)
• Positioning: Depth setting touch screen programmed by motorized backstop, side setting via drill heads

General Features

• Drill bit diameter: 1/8” – 5/8” (3 – 14 mm), with special drill heads up to 1 1/2” (38 mm)
• Maximum pile height: 2” (50 mm), optional 3” (75 mm)
• Space requirements: 37 1/2” (950 mm) wide, 35” (890 mm) deep, 56” (1,420 mm) high
• Power requirements: 400 volts, 3 phase, 50 cycles, 16A, 3 kW
• Air consumption for Cooling and lubrication: 100 litres per minute at 2 bar pressure

Technical data is subject to change without notice.